SAFETY NOTICES
Conduit
®
Base Station IP67 for Europe and Asia MTCDTIP-L4E1 Hardware Guide 19
Chapter 5 – Safety Notices
Installation Safety
This information is also available in the Installation Guide , in the box and available at
https://www.multitech.com/brands/multiconnect-conduit-ip67 Select your model to find the correct installation
guide for your device.
Warnings and Cautions
Warning and Caution symbols mean potential danger. You are in a situation that could cause bodily injury. Before
working on any equipment, be aware of hazards in the installation area and be knowledgeable about electrical
circuitry. Be familiar with standard practices for preventing accidents.
For translations of key cautions and warnings, refer Appendix A.
Warning: Only trained and qualified personnel should install, replace, or service this equipment. Installation
must comply with local and national electrical codes. Classification of use by: Skilled person
When installing or replacing the unit, the ground connection must always be made first and
disconnected last.
Disconnect PoE power (Ethernet PoE port) before servicing the device.
Do not work on the system or connect or disconnect cables during periods of lightning activity.
This device is not designed or approved to be used in any Hazardous Locations. Do not install or
operate device if area is known to be an explosive environment.
Externally ground this equipment using a customer-supplied ground wire before applying power.
Contact an electrician if you are uncertain that suitable grounding is available. Refer to Installing
the Ground Wire instructions in the Installation Guide (available at
https://www.multitech.com/brands/multiconnect-conduit-ip67 ). All wall mounting installations
are subject to the acceptance of local jurisdiction.
Do not locate antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme
care not to come into contact with such circuits, because they may cause serious injury or death.
For proper installation and grounding of the antenna, please refer to national and local codes.
Warning:
HOT SURFACE DO NOT TOUCH
Note: This symbol is included on the serial label. UL evaluated this device to a safety and outdoor
certification temperature of -30c to +70c.
Note: MultiTech recommends inspecting the mounting hardware every 3-6 months to ensure it has not become
loose or damaged due to weather conditions (such as lightning or wind) or a corrosive environment (such as
saltwater).
To Next Page
Loading...
