Multitech MTR-L4G1 - Restoring User Defined Settings to the Device

INSTALLING THE DEVICE
MultiConnect
®
rCell 100 Series Router LTE Cat 4 MTR-L4G1 Hardware Guide 21
Enter a new username and password to create your new administrative account. (Refer to
User Accounts in the appropriate software guide for details on username and password
requirements.)
Note: The device reboots when restoring settings.
Restoring User Defined Settings to the Device
You can restore user defined settings to your device.
You need:
A pin, paperclip, or similar thin object that can fit into the reset hole
1. Locate the hole in the panel labeled RESET. The reset button is recessed into the housing.
2. Use the pin to press in the button for about 3 seconds and then release the reset button.
a. If you do not press in the button long enough, the device will reset, but the user defined settings will
not be restored.
b. If you hold it too long, factory default settings will be restored.