Continuous Beep
Single Beep
Double Beep
Triple Beep
Single Pip
Double Pip
Triple Pip
Continuous Pip
Silent Alert
PIP/BEEP TONE ALERT PATTERN
MULTITONE
BEEP CODE
4
1
3
2
6
7
5*
8*
9
RPR 550IS Series
TM1188 Issue 1 Page 2 - 7
Table 2: Beep Alert Patterns and Beep Codes
NOTE: * The escalating alert and the Mute mode are overridden by beep code five
(triple pip) and beep code eight (continuous pip). They cause the alert to be
on full volume for the whole of the programmed alert time.
Extended Alert
15. If enabled and the call is not cancelled, the pager enters extended alert after the normal
alert has finished. During extended alert the LED flashes for 0.125s, every 2s. Two
0.125s pips (2s apart) are emitted every two minutes (unless in Mute mode). The pips
are synchronised to the LED flashes. However, the pips are suppressed if the call is
received with beep code 9. There is also 2s of vibrate every 2 minutes.
Vibrate Alert
16. The vibrate module provides an additional alert, operating 2s on, 2s off. Vibration is
included at every stage of the alert.
To Next Page
Loading...
