© Munters AB, 2020 90
12
Lighting Program
Trio supports on/off (non-dimmable) lights and dimmable lights. In setting up the
program, the following options must be defined:
•
On/Off and/or 0 – 10 Volt Variable Lights (defined in Devices and Sensors). A
system can include both.
•
Single line or multiline control: In single line control, all light lines have the same
output. In multiline control, the user defines the value (on/off or intensity level)
for each line.
•
Time: Starting time for each lighting event.
•
If a light sensor is installed, an alarm can be generated if the light goes below a
certain intensity.
•
On/Off Lights
•
0 – 10 Volt Variable Lights
•
Light Settings
12.1
On/Off Lights
1. To enable multi line control, go to Control > Light > Settings and enable Multi Line
Control (option).
2. Go to Control > Light.
To Next Page
Loading...
Need help?
General
