The modular transmitter is only FCC authorized for the specific rule parts listed on the grant;
when it is installed in a host device, the host product manufacturer is responsible for
compliance to any other FCC rules that apply to the host not covered by the modular
transmitter grant of certification. The final host product still requires Part 15 Subpart B
compliance testing with the modular transmitter installed.
If the WIT2420 is installed within another device the outside of the device into which the
WIT2420 is installed must also display a label referring to the enclosed module. The label
required for the WIT2420 module is as follows: Contains FCC ID: HSW-2420 and Contains
IC: 4492A-2420.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including inerference that may cause undesired operation.
WARNING: changes not expressly approved by the party responsible for compliance could
void the user’s authority to operate this device.
WARNING: a 20cm separation distance must be maintained between this device and the user.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
About This Manual
This manual is designed to allow integration of the Murata WIT2420 OEM module into
complete products. Care has been taken to try and make sure all of the information in this
manual is accurate. However, specifications can change over time and Murata cannot
guarantee the accuracy of this information. If you have any questions on any information in
this manual, please contact Murata Technical Support at (678) 684-2009.
To Next Page
Loading...