Muratec MFX-C2700 User Manual

Appendix A - menu system > 157
Print Setup
(cont.)
EPSON FX
Setup (cont.)
Tex t H eigh t Same Sets the height of a
character.
SAME: Regardless of
CPI, same height
DIFF: As CPI,
character heights
vary.
Network
Menu
Network Setup TCP/IP Enable Enables or disables
this network protocol.
IP Version IPv4 Set up the IP version.
Display condition:
TCP/IP protocol must
be enabled.
NetBEUI Disable Enables or disables
this network protocol.
NetBIOS Over TCP Enable Enables or disables
this network protocol.
Display condition:
TCP/IP protocol must
be enabled.
NetWare Disable Enables or disables
this network protocol.
EtherTalk Disable Enables or disables
this network protocol.
Frame Type Auto Selects the Ethernet
MAC layer frame type.
Display condition:
Netware must be
enabled.
IP Address Set Auto Specifies whether IP
address allocation is
automatic (DHCP) or
manually assigned.
Display condition:
TCP/IP protocol must
be enabled.
IPv4 Address xxx.xxx.xxx.xxx Current assigned IP
address.
To change, enter the
address using the
numerical keypad.
Press Enter to
register new address.
Display condition:
TCP/IP protocol must
be enabled.
Subnet Mask xxx.xxx.xxx.xxx Current assigned
subnet mask. To
change, proceed as
above.
Display condition:
TCP/IP protocol must
be enabled.
ITEM OPTION DEFAULT VALUE/DESCRIPTION

Muratec MFX-C2700 Specifications

General

Brand	Muratec
Model	MFX-C2700
Category	All in One Printer
Language	English