Section 78 00-02-1019
2018-03-02 - 12 -
Follow these steps to download a custom configuration using a USB drive:
Step Action
1 Create your custom configuration file within PowerVision.
2 Save the file to a USB drive.
3 Connect the USB drive to the USB port on the pigtail or on the USB on-the-go
connector provided with the programming kit.
4
Turn off the PV780B and turn it back on while holding down the bottom right key.
Continue to hold the button a few more seconds, then release once the screen
has entered into the bootloader.
5 Use the corresponding keys to the up/down arrows to find the desired file. Use
the corresponding right arrow key to select and continue. The right arrow turns
green; press again to confirm.
6 When the installation is complete, a check mark is displayed in the middle of the
screen. The PV780B will power cycle and boot to the new configuration.
To Next Page
