This page allows 8 parameters from different pages and for different parts to be displayed together on
the same page. Observe that when a parameter is edited, the part number part is shown on screen:
pt 1 oscillator 1 |waveform saw
wave squa|para 32|rang -12|tune 12
A particular quirk of this page is the specific function assigned to the encoder. Press it to
note to all parts. Press it again to send a note off message to all parts. This
allows Ambika to be used without a
keyboard. While a note is being played through this mean,
you can turn the encoder to transpose all parts up and down.
To select the parameters/parts shown on the performance page, press
performance page customization
knob 1|part 1|oscillator 1 parameter
Use the first knob to select the index of the knob you want to customize. Use the second knob to
select a part number. Use the third and fourth knobs, or the encoder, to scroll through the list of
Everything related to loading/saving patches, multi, etc. is done on this page. The data is stored on a
cards are supported) formatted in FAT16 or FAT32 format, inserted at the back of
Ambika. In case the SD card is incorrectly formatted, incorrectly inserted, or damaged, the following
text will be displayed every time you try to display the library page:
to continue and try blowing on the SD card connectors.
If the card is correctly inserted and formatted, the main library page will be displayed:
Ambika – User manual | Mutable Instruments http://mutable-instruments.net/ambika/manual
31 of 44 2/17/17 4:58 PM
To Next Page
Loading...
Need help?
General
