Mutable Instruments ambika User Manual

leds
: Disables the voicecard LEDs, in case you consider that synths should not be used as Diwali
decorations. Note that you need to reboot the unit for this setting to take effect!
auto (auto backup)
: Enables or disables the backup copy created on the memory card whenever an
item is overwritten. Disabling it will make saving faster.
It is also possible to save the current multi so that it is reloaded every time Ambika starts up. This is
very useful for saving your
MIDI
settings and favorite split/voice allocation parameters!
pt 1 program .A000 junon
pref|>ini|about more|exit
On this library page, press
S2
to select the
ini
command.
(?) use current multi as default?
yes | no
Press
S7
to confirm. The unit will freeze for a few seconds to write the current multi to its non-volatile
memory.
Firmware update
Firmware update through the SD-card
From the library page:
pt 1 program .A000 junon
| init|send|save|versions more|exit
Press
S7
to display more commands:
pt 1 program .A000 junon
pref|>ini|about more|exit
Press
S3
to bring the
about
page:
ambika v1.0|port 1 device 1 v1.0
Ambika – User manual | Mutable Instruments http://mutable-instruments.net/ambika/manual
36 of 44 2/17/17 4:58 PM

Mutable Instruments ambika Specifications

General

Brand	Mutable Instruments
Model	ambika
Category	Synthesizer
Language	English