MUTOH Ultima SC-850D - 2. INSTALLATION PROCEDURES; 2.1. PREPARING THE CUTTING ENVIRONMENT

Installation Instructions English - Ultima
11
AP-75125, Rev 2.2, 20/04/07
2. INSTALLATION PROCEDURES
2.1. PREPARING THE CUTTING ENVIRONMENT
The location where you set up your equipment is very important. Please see to it that it meets following
conditions:
Power supply of 100 to 120 VAC 50/60 Hz or 200 to 240 VAC 50/60 Hz.
Ambient Conditions
:
Operating environment
- Temperature: 5 °C to 30 °C
- Humidity: 35 % - 75 % non-condensing.
Recommended environment
- Temperature: Room temperature 16 °C to 25 °C
- Humidity: 50 % to 65 %, non-condensing.
Variation rate
- Temperature: 2 °C per hour.
- Humidity: 5 % per hour.
Storage environment
- Temperature: 0 °C to 50 °C
¾ Please protect your cutter from moisture, dust, draughts and direct sunlight. It is best to keep your
machine away from open windows and air-conditioners.
¾ See to it that there is an adequate space around the cutter so that ventilation is not obstructed.
¾ Avoid unnecessary vibrations and set up your cutter on a level surface.
¾ When selecting a place for your cutter, leave at least 90 cm in front and 90 cm at the rear, as shown in
the illustration below.