Need help?Do you have a question about the MUTOH ValueCut VC-1800 and is the answer not in the manual?
General| Contour Cutting | Yes |
|---|---|
| Drive Method | Servo Motor |
| Media Types | Vinyl, Reflective material, Paper |
| Connectivity | USB, Ethernet |
| Repeatability | 0.1 mm |
General safety guidelines and personal precautions for operating the plotter.
Flowchart illustrating the plotter's system architecture.
Schematic showing electrical connections and component layout.
Guide for replacing components and adjusting belt tension.
Step-by-step instructions for removing machine covers.
Procedure for replacing the pinch roller sets.
Steps for successfully replacing the tool carriage.
Instructions for replacing the Y-motor unit.
Steps for safely connecting or replacing the main board.
Guide on how to upgrade the machine's firmware.
Instructions on how to back up machine settings.
Introduction to diagnostic features for hardware checks.
How to initiate the plotter's diagnostic facility.
Flowchart of the diagnostic test sequences.
Tests for X, Y motor encoders and tool holder encoder.
Diagnosing movement issues with X, Y motors and drivers.
Tests for RS-232, Printer Port, and USB port connectivity.
Troubleshooting steps for issues with line quality at plot ends.
Solutions for media width detection problems due to pinch rollers.
To Next Page