Mutsy EVO - Reclined Carriage Position; Leg Support Adjustment; Bumper Bar Attachment and Removal; Hood Adjustment

11
Reclined carriage position (t)
· The seat has a reclined carriage position to make the seat suitable for
children from birth. The use of a suitable cot is always recommended
and preferred for children from birth up to the age that your child can
sit up unassisted.
· To put the seat in the reclined carriage position, put the leg rest in its
highest position and the backrest of the seat in its fully reclined posi-
tion. Release the two press studs on each side of the seat.
· Open the zipper around the leg support. There is a fabric wall in the
pocket behind the leg support, which you can pull out. Now you can
put the wall up and attach the two press studs on each side onto the
seat. The press studs of the seat can now be attached to the press studs
of the wall.
Adjust the leg support (u)
· Lift the leg support to place it upwards.
· Push the buttons on both sides of the leg support and push the leg
support downwards to lower it.
Attach and remove bumper bar (u)
· Push the ends of the bumper bar in the thereto designated notches in
the seat until you hear a click.
· Press the unlock buttons on both sides of the bumper bar and remove
the bumper bar from the seat.
The hood (v1, v2)
· Hold the front hood bar in the centre and move it forwards or rear-
wards to adjust the hood. (v1)
· Open the zipper in the centre to further enlarge the hood. Close the
zipper to again reduce the hood. (v2)
· Pull the ap on the front side of the hood outwards to additionally en-
large the hood. Push the ap inwards to again reduce the hood.
The integrated foot step (w)
· There is a zipper around the leg support of the seat. If so desired you
can open this zipper to thus create a higher foot rest for your child. The
child can then place the feet on the aluminium bar of the leg support.
When your child gets bigger you can again close the zipper and your
child can place the feet on the plastic foot rest of the frame.
Assemble the rain cover on the seat (x)
· Make sure that the hood of the seat is in the upright position.