9
sides. Be careful! The carry cot is now unlocked; the red sections on the
chassis attachment points are now visible. Take the carry cot rmly by
the handle on the hood and remove it from the chassis in a vertical
movement.
The hood (m)
· The hood can be unfolded by moving it upwards.
· Push and hold the buttons on the sides of the hood. The hood can now
be folded downwards.
Assemble the rain cover on the carry cot (n)
· Make sure that the hood of the carry cot has been unfolded.
· Place the rain cover from top to bottom over the carry cot and make sure
that the rain cover attaches well all around the bottom of the carry cot.
· Close the Velcro strips around both sides of the chassis.
· Open the zipper in order to remove your baby from the carry cot when
using the rain cover.
The seat (6 months – 25 kg)
· The seat is suitable for children from 6 months up to 25 kg who can sit
independently.
· When in the drive position, the seat can be folded and unfolded with the
chassis and does not therefore need to be removed from the chassis.
· The back support and leg support are adjustable.
· Make sure that the chassis has been fully unfolded and the brake is
blocked during all actions indicated below.
Moving the seat unit to face forwards (o)
· Place the attachable elements on the seat into the attachment points
on the chassis and press the seat downwards until you hear a click on
both sides. NB! Place both ridges on the attachment elements into the
chassis attachment points at the same time.
· Check that the chair has been attached solidly by trying to lift it from
the chassis.
Moving the seat unit to face backwards (p)
· In order to place the seat unit so that it is facing backwards, the at-
tachment elements on the seat need to be turned by 90 degrees.
Press the button (p1), the attachment elements will unlock and spring
out. Turn the attachment elements to the correct setting and then
click into place.
· Then place the attachable elements on the seat into the attachment
To Next Page
Loading...
