Mutsy IGO - Safety Harness and Car Seat Integration

12
over the leg support.
The 5-point safety harness (x1, x2)
· Place your child in the pushchair and make sure that the legs of your
child are placed on each side of the leg piece.
· Make sure that the hip and shoulder belt is positioned correctly over
your child and place both plastic clamps in the central part of the har-
ness attached to the leg piece (x1).
· To adjust the length of the shoulder straps, loosen the shoulder pro-
tectors from the belt by undoing the velcro. This will reveal the belt
buckles. Adjust the length by sliding the buckles along both shoulder
straps until your child is comfortably secure. After adjusting, press
down the velcro on both sides to relock the shoulder protectors in
place.
· The back support contains three positions for the shoulder belts. To
adjust the position, open the panel behind the back support (x2).
Loosen the shoulder belts by moving the attachment rings through
the openings. Move the attachment rings through the desired open-
ings so that the shoulder belts are positioned properly and click the
panel back.
· Regularly check the length and position of the belts and adjust, where
necessary.
Maxi-Cosi car seat
· The Maxi-Cosi car seat adapters are suitable for use with the following
Maxi-Cosi group 0+ car seats: Maxi-Cosi Mico, Maxi-Cosi Citi.
· Always observe the instructions in the manual of your Maxi-Cosi car
seat before you start using the car seat.
· Make sure that the chassis has fully been unfolded and the brake
blocked during all actions indicated below.
Place the Maxi-Cosi adapters on the chassis (y)
· The adapter marked with ‘R’ is placed on the right side of the chassis,
the adapter marked ‘L’ is placed on the left side.
· Slide the adapters in the attachment parts and press solidly until you
hear a click.
Place the Maxi-Cosi car seat on the adapters
· Orientate the Maxi-Cosi car seat such that it is directed rearwards on
the chassis.
· Hold the Maxi-Cosi car seat with the central hinge points of the support
bar directly above the adapters.