10
points on the chassis and press the seat downwards until you hear a
click on both sides. NB! Place both ridges on the attachment elements
into the chassis attachment points at the same time.
· Check that the chair has been attached properly by trying to lift it
from the chassis. NB! The chassis cannot be folded with the seat fac-
ing backwards!
Remove the seat (q)
· Slide the unlocking buttons upwards until you hear a click on both
sides. Be careful! The seat is now unlocked; the red section on the
chassis attachment points are now visible. The seat can vertically be
removed from the attachment points.
Adjust the back support (r)
· Pull the button at the back of the seat upwards and hold it upwards.
· The back support has 4 positions. Place the back support in the desired
position and release the button to lock the position.
Reclined carriage position (s)
· The seat has a reclined carriage position to make the seat suitable for
children from birth. The use of a suitable carry cot is always recom-
mended and preferred for children from birth up to the age that your
child can sit up unassisted.
· To put the seat in the reclined carriage position, put the leg rest in its
highest position and the backrest of the seat in its fully reclined posi-
tion. Release the two press studs on each side of the seat. Open the zip-
per around the leg support. There is a fabric wall in the pocket behind
the leg support, which you can pull out. Now you can put the wall up
and attach the two press studs on each side onto the seat. The press
studs of the seat can now be attached to the press studs of the wall.
The hood of the seat needs to be in the rst upright position. There are
2 straps on either side of the seat to keep the canopy in this position.
Make sure the two straps on either side of the seat are attached to the
press studs on the canopy.
Folding the chassis with the seat facing forwards (t)
· Stand behind the chassis and put the chassis on the brake. Fold the
hood back if it is folded out. Fold the seat unit in two by tilting the back
support forwards (t1).
· Push the height adjustment button (t2) of the pushbar in and move this
to the lowest setting. Pull the folding safeguard (t3) towards you on
both sides and turn the pushbar forwards until the pushbar lies on the
To Next Page
Loading...
