11
frame (t4).
· Pinch the chassis unlocking buttons and fold the chassis (t5).
· The folding safeguard locks automatically when the product is folded up.
· The integrated carry handle, which is located under the rear axle,
has made lifting and carrying the folded pushchair more practical.
· NB! The chassis cannot be folded with the seat facing backwards!
Unfolding the chassis with the seat (a, b)
· Press the folding safeguard inwards (a1) and tilt the upper chassis until
the lower support clicks into place (a2) and move the pushbar back-
wards until you hear a second click (b).
· After unfolding the seat, always push the bumper bar to its upright po-
sition before placing a child in the seat. Make sure that no child is near
the bumper bar when moving it.
· Before use always check that the cot has been unfolded and secured
correctly.
Attach and remove bumper bar (u1)
· To secure the front bumper, press the ends of the bumper into the re-
cesses intended for this purpose on the seat until you hear a click.
· Press the unlock buttons on both sides of the front of the bumper bar
to remove the bumper bar from the chair.
Adjust the leg support (u2)
· Lift the leg support to place it upwards.
· Push the buttons on both sides of the leg support and push the leg
support downwards to lower it.
The hood (v1, v2)
· Hold the front hood bar in the centre and move it forwards or rear-
wards to adjust the hood (v1)
· Open the zipper at the back of the opened hood in order to enlarge it.
Close the zipper to again reduce the hood (v2)
· Pull the ap on the front side of the hood outwards to additionally en-
large the hood. Push the ap inwards to again reduce the hood.
Assemble the rain cover on the pushchair (w)
· Make sure that the hood of the seat is in the upright position.
· Open the zipper in the rain cover in order to attach it to the enlarged
hood of the seat.
· Place the rain cover from top to bottom over the pushchair and make
sure that the rain cover is attached well behind the back support and
To Next Page
Loading...
