What to do if my MZ electronic Cash Counter shows 'LOW VOLTAGE'?
If your MZ electronic Cash Counter displays a 'LOW VOLTAGE' error, it indicates that the power supply voltage is below 10V. You should verify the battery charge or check the operation of the electrical system.
What to do if MZ electronic Cash Counter shows 'STOP 3.2 m NO SENSOR'?
If your MZ electronic Cash Counter displays 'STOP 3.2 m NO SENSOR', it means the instrument isn't receiving a signal from the magnetic sensor for more than 5 seconds, even when the UP or DOWN keys are pressed. Here's what you can do: * Check the sensor's electrical connections. * Verify the sensor's operation and replace it if necessary. * Check the position and distance (3 mm) between the sensor and magnet on the gipsy. * Check the operation of the electric installation or anchor windlass.
Steps for installing the magnetic sensor on vertical shaft windlasses.
Steps for installing the magnetic sensor on horizontal shaft windlasses.
Enabling and configuring the automatic anchor lowering function.
Diagnosing and resolving issues when no sensor signal is detected.
Diagnosing and resolving issues related to low power supply voltage.
General| Brand | MZ electronic |
|---|---|
| Model | HC020 |
| Category | Cash Counter |
| Language | English |
To Next Page
