Need help?Do you have a question about the MZ electronic EV-040 and is the answer not in the manual?
General| Brand | MZ electronic |
|---|---|
| Model | EV-040 |
| Category | Cash Counter |
| Language | English |
Drill a hole, insert magnet, and fix with adhesive. Ensure protrusion does not interfere with rotation.
Drill a hole for the cable, attach support A, position sensor on B, align with magnet, and secure.
Drill cable hole, attach support A, cut Part C, position sensor 3mm from magnet, and fix with adhesive.
Open transmitter cap, insert charger plug with reference mark up. Plug into cigarette lighter. Blue LED indicates charging.
Enter the gipsy circumference in cm or inches. Use Table 1 for calculation. Default is 33 cm.
Set based on inductive sensor type and number of gypsy signatures from Table 1. Default is 1 for 2-wire sensor.
Enter the reduction factor for Project series sensors. Refer to Table 2 for correct values. Default is 57.
To Next Page
