What to do if the MZ electronic Cash Counter shows a circle with an exclamation point?
If the MZ electronic Cash Counter displays a circle with an exclamation point, it means the control unit can't communicate via radio, interrupting maneuvers. Ensure the receiver is on. If it is, try the radio pairing procedure between the transmitter and receiver.
Why is my MZ electronic Cash Counter not getting any signal from the magnetic sensor?
If the MZ electronic Cash Counter doesn't receive a signal from the magnetic sensor when pressing the UP or DOWN keys for more than 5 seconds, check the sensor's electrical connections and its operation. Replace the sensor if it's not working correctly. Also, verify the position and distance (3 mm) between the sensor and magnet. Finally, inspect the operation of the electrical installation or anchor windlass.
What to do if the MZ electronic Cash Counter's power supply voltage is low?
If the MZ electronic Cash Counter's power supply voltage is lower than 10V, verify the battery charge or the operation of the electrical system.
General| Brand | MZ electronic |
|---|---|
| Model | WHC040 |
| Category | Cash Counter |
| Language | English |
Details on drilling and fixing the magnet onto the windlass gipsy for chain counting.
Instructions for mounting the magnetic sensor and aligning it with the magnet.
Steps for installing the magnetic sensor and aligning it with the magnet on horizontal windlasses.
Details the pin assignments for the 12-poles terminal block in the receiver unit.
Explains how to change the device between windlass and capstan operating modes.
Allows selection of the operating mode: Windlass (WND) or Capstan (CAP).
Resets the chain measurement value to 0.0, allowing confirmation with Yes/No.
Allows selection between Feet/inches and Metres/centimetres for measurement.
Allows programming the display contrast by enabling this function.
Allows programming the display luminous intensity by enabling this function.
Selects the sensor type: 2-wire standard (STD) or 3-wire electronic (HAL).
Enters the circumference of the gypsy in cm or inches for calibration.
Sets the divider value based on sensor type and gypsy teeth for calibration.
Switches on all display pixels to check for defects.
Displays the installed software version.
Indicates the total hours of winch operation.
To Next Page
