Up Alarm
It is possible to enable the function and
establish the height at which the anchor-
winch stops; after which it is only possible to
give pulsed commands.
Settable values: OFF, 0.5 – 1.0 – 1.5 – 2.0 –
2.5 - … 10.0 (metres or feet).
Select with
Select value with
Confirm with
Auto Down
Enables the automatic anchor lowering
procedure, at the desired height, with the
pressing (for at least 3 seconds) of the keys
and .
Settable value: OFF, 1,2,3…25 (metres or
feet).
Select with
Select value with
Confirm with
Load Default
This function allows the User to revert to the
original factory default settings, thus erasing
all settings memorised.
This command must only be used in the
event of programming errors.
Select with
= Yes = No
Confirm with
Exit
To return to the previous menu.
SETTINGS
LITE 5
OFF TIME 30
LANGUAGE ITA
EXIT
CONTRAST 3
Use the (DOWN) or (UP) key to move around the parameters.
Contrast
By enabling this function it is possible to start
the display contrast programming procedure.
Select with
Select value with
Confirm with
Lite
By enabling this function it is possible to start
the display luminous intensity programming
procedure.
Select with
Select value with
Confirm with
To Next Page
Loading...
