MZ electronic WHC040 - Chain Counter Installation; Wiring Connections

WHC040 Rev. 01-2021
English
19
Installing the chain counter
(see connection diagram at page 73/74)
Warning
ALWAYS DISCONNECT THE BATTERY PRIOR TO INSTALLATION.
Connections
12-poles Terminal Block in the receiver
PIN
SEGNALE
POS
- Battery
NEG
+Battery
UP
UP Command
DOWN
DOWN Command
SW-M
Magnetic sensor (1st wire)
SW-M
Magnetic sensor (2nd wire)
BO-L
Bow Left Command
BO-R
Bow Right Command
ST-L
Stern Left Command
ST-R
Stern Right Command
CAN-H
CAN-H signal (CanOpen serial interface)
CAN-L
CAN-L signal (CanOpen serial interface)
Sensor holes
min.44 mm(1”3/4)
4
magnetic sensor
sensore magnetico