MZ electronic WHC040 - Sensor Test Procedure; Test Menu Options; LCD Display Test; Software Version Information

WHC040 Rev. 01-2021
English
26
Test
This function allows you to check the correct
operation of the tachometer sensor: a screen
with the status of the sensor is displayed: by
rotating the winch, the contact must close
when the mangete passes in
correspondence with the sensor, closing it.
SENSOR
Exit
To return to the previous menu.
Confirm with
Test menu
TESTS
SOFTWARE 1.0
WORK. HOUR 0
EXIT
LCD TEST
Use the (DOWN) or (UP) key to move around the parameters.
LCD Test
This function switches on all the display’s
pixels thus making it possible to perform a
check on them.
Select with
Confirm with
Software Version
Indicates the version of the software installed.
Work Hours
Indicates the hours of operation of the winch.
Exit
To return to the settings menu.
Confirm with