EV-040 Rev. 10 – 2014
21
Parameter Default value
Up Alarm 3.0 metres
Auto Down Off
Turnoff Time 30 seconds
Units of measurement Metres/centimetres
Chain Measure 0.0 metres
Barbotin Circumference 33 cm
Sensor type unknown
Language Italian
Works Hours 0
Division factor 1
Chain counter setting menu
Hold down the (ON) key for six seconds
to access the instrument setting menu. The
following page will appear on the display:
Menu
M ea s ur e
A l a r m s & F u n c t i o n
S e t t i n g s
L a n g u a g e
S e n s o r C a l i b r a t i o n
Use the (DOWN) and (UP) keys to
move around the menu options.
Menu
L a n g u a g e
S e n s o r C a l i b r a t i o n
Te s t s
E x i t
Once you are positioned on the item to be modified press the (ON) key to confirm your
choice.
Use the (DOWN) or (UP) keys to move from one parameter to another.
Once one is positioned on the parameter press the (ON) key to enable modification.
According to the type of parameter, using the (DOWN) and (UP) keys it is possible to
reduce/increase the value of the same or disable/enable the function.
Once the modification has been performed, press the (ON) key to confirm.
Using the (DOWN) key go to the Exit option and press the (ON) key again to return to
the setting menu. The same procedure must be used to return to the main page.