MZ electronic EV-040 - Settings Menu

EV-040 Rev. 10 – 2014
English
23
This function allows the User to revert to the
original factory default settings, thus erasing
all settings memorised.
This command must only be used in the
event of programming errors.
= Yes = No
Confirm with
Exit
To return to the settings menu.
Confirm with
Settings menu
Settings
C o n t r a s t
L i g h t
Tu r n o f f Ti m e 3 0
E x i t
Use the (DOWN) or (UP) key to move around the parameters.
Contrast
By enabling this function it is possible to start
the display contrast programming procedure.
Select with
Select value with
Confirm with
Light
By enabling this function it is possible to start
the display luminous intensity programming
procedure.
Select with
Select value with
Confirm with
Turnoff Time
This function allows the user to set the turnoff
time after the last command given (default
value 30 seconds).
Select with
Select value with
Confirm with
Exit
To return to the settings menu.
Confirm with