N-Com B1 User Manual

B1
15
5.1. Basic functions
All N-Com system functions are available through the operation of three pushbuttons: “”,
“on” and “ ”. Every time the system is given a command, a special acoustic signal can be
heard, which varies depending on the function being requested. This way, all the functions
can be used while wearing the helmet.
The type of command given to the system depends on how long the pushbutton is pressed.
System ON
Press “on” and keep it pressed for about 2 seconds, until the
LEDs turn on and you hear a beep in the headset.
System OFF
Press “on” and keep it pressed for about 4 seconds, until the
LEDs turn off and you hear a beep in the headset.
Increase Volume
Briefly press “” to increase the volume. A double tone signals
the highest volume level.
Decrease Volume
Briefly press “” to decrease the volume. A double tone signals
the lowest volume level.
5.2. N-Com Wizard
“N-Com Wizard” is the PC application that can be used to manage and
configure the B1 system.
The programme can be downloaded from the Internet site www.n-com.it, in the
“Download” section. In order to use it, a helmet equipped with B1 must be connected to
the PC, using the USB cable supplied with the system.
N-Com Wizard allows you to customize your B1, specifically:
 Setting the system audio levels
 Update the device firmware
The programme includes an on-line guide that explains how it works (after installing it on
your PC, press F1 to display this guide).
6. PAIRING UP BLUETOOTH DEVICES
In order for the B1 system to be connected to another Bluetooth device, the latter needs
to be first paired up with the N-Com system.
The pairing up procedure is the same for all Bluetooth devices: mobile phones, MP3
Bluetooth players, satellite navigators, etc.
1. Make sure the B1 is turned off;
2. Press “on” and keep it pressed (for more than 6 seconds), until the LEDs start to
flash quickly and you hear a sharp beep in the headset, indicating the “Pair-up
mode”;
3. On the Bluetooth device, turn on the search for Bluetooth devices (refer to the
instructions manual of your device for the proper pairing up procedure, as it
varies depending on the brand and model of the device);
4. After a few seconds, the device will display the name “N-Com B1 v.X.XX”,
followed by the manufacturer’s identification data;
5. Select the N-Com device. If a password is requested, enter 0000 (four zeros);
6. B1 will confirm the pairing up by means of a tone in the headset, and the LEDs
will stop flashing;
7. Turn off and on both the device and the B1 to store the pairing up data.
Note: The affiliation is stored in the helmet and in the cell phone and it is not lost when
the two devices are turned off. As a result it needs to be carried out only once.

N-Com B1 Specifications

General

Brand	N-Com
Model	B1
Category	Headsets
Language	English