N-Com B1 User Manual

B1
7
3. INSTALLATION
Fig. 1
Fig. 2
Fig. 3
 Remove the “N-Com” protection plate
located on the helm
et shell (Fig. 1)
and open the helmet chin guard (flip
up helmets).
 Remove the right and left cheek pads
from the helmet (see specific
instructions provided in the user
manual of the helmet).
 Remove the Noise Reducers from the
two cheek pads, and tear off the pre-
cut plastic (if equipped).
Fig. 4
Fig. 5
Fig. 6
 Remove the back of the comfort
padding by pulling on the neck roll
until it separates from the shell (Fig.
4).
 Temporarily put the padding on the
outside of the helmet (Fig. 5).
 Remove the N-Com cover from the
helmet border gasket. Push from the
inside of the helmet to facilitate the
removal (Fig. 6).

N-Com B1 Specifications

General

Brand	N-Com
Model	B1
Category	Headsets
Language	English