N-Com B1 User Manual

B1
17
Note: If the navigator is pre-set for connection to a Bluetooth mobile phone, you will be
able to receive the phone call audio directly in the helmet through the GPS. In this
case, you can answer the call directly from the navigator.
GPS Conference Call Function
The Conference function allows you to keep the “Rider-Pillion Passenger” intercom open
even while the satellite navigator is giving instructions, thus preventing the intercom mode
to be turned off every time the navigator gives instructions. However, if you wish to
activate the Conference GPS function, simply turn on the intercom manually during the
GPS directions (by briefly pressing “on”).
Caution: this function is available only if the Pillion Passenger helmet is also equipped with
a N-Com system provided with the same function.
At the end of the GPS communication, the intercom with the second helmet stays open and
the "Conference" setting is stored for future GPS communications.
9. BLUETOOTH A2DP MUSIC PLAYER
You can listen to high quality music by connecting B1 to a device equipped with Bluetooth
A2DP (Advanced Audio Distribution Profile) protocol.
The B1 system is also equipped with Bluetooth AVRCP (Audio Video Remote Control
Profile) protocol, which allows you to stop and resume music reproduction directly from the
helmet (with devices equipped with AVRCP).
Connection to A2DP music
player
The connection is automatic when you turn on the
system. Wait a few seconds for the connection.
Play music (Play) Press the “” button and keep it pressed for 2 seconds.
Pause function (Pause)
When the player is connected and playing music, press
“” for 2 seconds.
Next track (Skip)
When the player is playing music, press “” for 4 about
seconds.
Stop playing music (Stop) Press “” for 2 seconds.
Note: The Bluetooth intercom does not work while listening to an A2DP audio source or an
un Mp3 player connected via cable.
10. AUDIO DEVICES WITH CABLE CONNECTION
N-Com B1 allows connection via cable (sold separately) to audio sources equipped with the
3.5mm output generally used by these devices for the headsets.
To listen to the audio source, connect the cable to the helmet using the micro-USB port,
then start playing the audio file on the device, then activate the audio peripheral device
using the specific key.
You can turn on or off listening in the helmet by pressing the “” key for 2 seconds.
N.B. : You cannot stay connected in intercom mode with the pillion passenger while using
the audio source via cable.

N-Com B1 Specifications

General

Brand	N-Com
Model	B1
Category	Headsets
Language	English