N-Com B901L - 6 Pairing up with Mobile Phones or Other Bluetooth Devices; 7 Mobile Phone; Speed Dial

EN
16
6. PAIRING UP WITH MOBILE PHONES OR OTHER BLUETOOTH DEVICES
 Make sure the B901L is turned off;
 Put the system in the “Configuration” mode, then press the “ON” key and keep it pressed
for 4 seconds, until you hear the voice announcement “ Configuration ”;
 Press the key “” to access the “Mobile phone pair up mode””.
 Turn on the search for Bluetooth devices (smartphone, GPS, MP3 reader) on the device;
 Select the N-Com device. If a password is requested, enter 0000 (four zeros);
 Connection between the two devices is established after a few seconds.
Note: The affiliation is stored in the helmet and in the cell phone and it is not lost when the two
devices are turned off. As a result it needs to be carried out only once.
Automatic Connection
Once the Bluetooth device has been paired up, connection is automatic
when the system is turned on.
Manual Connection
In case
connection is not automatically initiated after a few seconds, you
can connect from the Bluetooth device or by pressing “ON” and keep it
pressed for about 2 seconds.
7. MOBILE PHONE
To pair up a mobile phone to the B901L system, follow the procedure illustrated in Chapter 6.
Answering a phone call Briefly press any key when you hear the incoming call signal.
Vocal answer When you hear the ringtone, say any word out loud.
Voice call Press “ON” and keep it pressed for about 2 seconds.
Hanging up/rejecting a
phone call
Press “ON” and keep it pressed for about 2 seconds.
Manual phone
connection
Press “ON” and keep it pressed for about 2 seconds.
7.1. Speed dial
Using the N
-
Com EASYSET program or the N
-
Com EASYSET App, you can store
up to 3 of your favourite numbers, which you will be able to dial from the
“ Speed Dial ” menu.
Saving the Speed Dial numbers
To assign one or more speed dialling numbers:
 Put the system in the “Configuration” mode: starting from a switched off system, press the “ON”
key and keep it pressed for 4 seconds, until you hear the voice announcement “ Configuration ”.
 Press the key “” or “” until you hear the voice command “ Speed dial ”.
 Press the “ON” confirmation key. You will hear the voice announcements “ Speed dial 1 ” and
“Phone connected” .
 Press the keys “” or “” to select the speed dialling number to be assigned. The saved position
is confirmed by the voice announcement “Speed dial 1 / “ Speed dial 2” / “Speed dial 3” .
 On your own mobile phone (paired up and connected to the N-Com system), call the phone
number you wish to assign to the selected speed dialling position. The call is interrupted before it