20
14.4.
Smart Conference
(Group Intercom)
Thanks to the “Smart Conference” function, you can start the conference communication between N-
Com intercom systems of the “900” series previously paired up and saved in the 3 available channels.
All systems must be turned on and available within the connection range.
1. Each system must have been previously paired up to all the other systems: B, C and D.
2. Any system can press the “
n” key for 2 seconds to activate the Group Conference or to start
a conference communication between all the systems.
3. In the case where one of the systems presses the “
n” key or falls outside the connection
range, the group intercom is interrupted.
or 2 seconds. Activation is confirmed by a beep in the
helmet and by the voice message “
Group Intercom”
.
” key. Disconnection is confirmed by the voice
announcement “
Group Intercom terminated
”.
Note: During a “Smart Conference” call, connection to the mobile phones of all participants is
temporarily cut off. When the conference call ends, all phones automatically reconnect to their own
intercom system.
Note: The “
Smart Conference
” mode can be used EXCLUSIVELY with “900” series N-Com systems”.
Note: The “
Smart Conference
” mode CANNOT be used with systems paired up in Universal Intercom
mode (chapter 15.1).
To Next Page
Loading...
Need help?
General
