N-Com B901L - 14 Intercom; N-Com 900 Series Intercom Pairing up; Pairing up Other N-Com Intercoms

21
14. INTERCOM
The N-Com B901L system allows communication with other N-Com systems, up to a maximum
distance of about 700 m (in open field, with no obstacles). The range of the communication varies
depending on the N-Com systems used.
N.B.: The range and quality of the communication may vary significantly depending on the presence
of obstacles, weather conditions, magnetic fields.
14.1. N-Com “900” Series Intercom pairing up
Important: The procedure described below refers exclusively to the pairing up between the “900”
series N-Com systems.
 Make sure the systems are turned off;
 Put the systems in “Configuration” mode: press the “ON” key and keep it pressed for 4
seconds, until you hear the voice announcement “ Configuration ”;
 On both systems, press the key “” until you reach the option “ Intercom pairing ”;
 On system A, press the key pertaining to the “pre-setting position” where you wish to save
system B.
Pairing up CHANNEL 1
Briefly press “
n
”.
Pairing up CHANNEL 2
Press the “
n
” key twice.
Pairing up CHANNEL 3
Press the “
n
” key three times.
The Intercom connection with the selected channel is automatically activated at the end of the pair up
procedure.
14.2. Pairing up other N-Com intercoms
Important: The procedure described here below refers exclusively to the pairing up of “900” series N-
Com systems with N-Com systems OTHER THAN the “900” series
1
.
 Make sure the systems are turned off;
 Put the N-Com system in “Setting” mode: press the “ON” key and keep it pressed for 4
seconds, until the blue LED starts to flash quickly;
 Put B901L system in “Configuration” mode: press the “ON” key and keep it pressed for 4
seconds, until you hear the voice announcement “ Configuration ”;
 On B901L system, press the key “” until you reach the option “ Intercom pairing ”;
 Press the “ON” key: selection of the right pairing up mode is confirmed by a change in the
“standby” tone (high beep) and by the voice announcement “ Pairing up other N-Com
systems ”;
 On B901L system, press the key pertaining to the “pre-setting position” where you wish to
save the other N-Com system.
Pairing up CHANNEL 1
Briefly press “
n
”.
Pairing up CHANNEL 2
Press the “
n
” key twice.
Pairing up CHANNEL 3
Press the “
n
” key three times.
1
Except for Bluetooth kit and Bluetooth kit2, which are not compatible