Rev. 9-09-16 Part #C-00084
www.NabcoEntrances.com Magnum 4A Control Wiring and Adjustment Manual
Geng Started 2-5
►
► Replaces all Magnum controls.
► Replaces the analog swing control (requires two controls for sim pair installations).
►
►
► Digital parameter settings for repeatability.
►
controls required for sim pair and bifold applications).
►
►
►
encoder motor.
►
►
► Two transistor outputs with programmable functionality for air curtains or other devices.
►
► Recycle on object detection during Opening cycle with all motors.
►
► Full Power or Low Energy application capability.
►
might be commonly used. Onsite wiring may be different from that shown.
Table 2-1 Sensors
Sensor Part Number Function Power Source Current Consumption
Acuvision Infrared
Acuwave Infrared
Infrared
Infrared
Table 2-2 Modules
Module Part Number Function Power Source Current Consumption
RF Signal Transmission 50mA
Multi Module Programmable Relay 40mA