Need help?Do you have a question about the Nacra F-18 and is the answer not in the manual?
Assembling the boat hulls, ensuring correct orientation and connection of beam components.
Installing the trampoline onto the forward beam and hull tracks, securing it with tie lines.
Assembling and adjusting spreader arms and connecting them to the mast for sail support.
Attaching the rotator wishbone to the mast, ensuring it avoids boom contact during sailing.
Attaching downhaul swivel blocks to the base of the mast for sail control.
Routing main and spinnaker halyard lines through masthead sheaves and blocks.
Attaching shrouds, forestay, and trapeze wires to mast hound and hull fittings.
Assembling the forestay and drum for the roller furling jib system.
Installing the downhaul retractor kit system for sail control.
Installing rotator cleats on the forward beam for sail control lines.
Installing shroud adjusters on the hulls for tensioning the rigging.
Installing bridle wires and the forestay assembly onto the hulls.
Setting up trapeze lines with shock cord and rings for crew support.
Safely raising and securing the mast onto the boat's base and rigging.
Aligning rudder blades correctly for proper steering and boat control.
Installing and routing jib sheet lines and cleat blocks for sail control.
Connecting the boom to the mast via the gooseneck assembly.
Setting up the rotator system with lines, blocks, and wishbone for sail control.
Routing mainsheet lines through blocks and traveler car for sail control.
Installing and threading traveler line for adjusting mainsheet position.
Installing and setting up jib halyard and sail for hoisting and control.
Inserting battens and preparing the mainsail for hoisting.
Procedure for raising the mainsail onto the mast.
Procedure for safely lowering the mainsail from the mast.
Attaching ratchet blocks and preparing the spinnaker system.
Installing the spinnaker pole and associated bridle wires.
Assembling and installing the spinnaker snuffer system components.
Specific details for attaching snuffer bridles on the Inter 17 model.
Setting up the continuous spinnaker halyard for the snuffer system.
Setting up the control lines for the self-tacking jib system.
Procedures for righting the catamaran after it has capsized.
Guidelines for safely trailering and storing the catamaran.
Information on the approved design category for the craft's usage.
Details regarding the catamaran's capabilities and recovery after capsize.
Important general information and safety notes for operating the catamaran.
Table detailing recommended and maximum load capacities for various models.
Information on what is covered under the manufacturer's limited warranty.
Procedure for obtaining warranty service for the catamaran.
Critical safety warnings regarding electrical hazards and mast handling.
Information on services provided by authorized local dealers.
To Next Page
General