NAD 7100 Series - Front Panel Overview; Front Panel Controls; Rear Panel Overview; Rear Panel Connections

FRONT PANEL
1. Power. 9. Tape 1, Tape 2 (Monitor). 17. Mono.
2. Phones. 10. Input Selector (Phono, Video, CD). 18. AM/FM.
3. Speaker Selector. 11. Low Level. 19. Narrow 1.F.
4. Bass Eq. 12. Balance. 20. Tuning Display.
5. Bass. 13. Volume. 21. Tuning Up/Down.
6. Loudness Compensation. 14, Pre-sets. 22. Search mode.
7. Treble. 15. Bank Selector.
8. Tape Copy. 16. Memory Enter.
14 15 16 17. (18 19 20 22 21
=a
panned
w=
SOFT
CLIPPING
V
TUNING
&
INAD Monitor Series Stereo Receiver 7100 (taal = FM STEREO G an
Le ay,
SEARCH
(Mail
: HL)
SPEAKERS BASS EQ BASS TREBLE COPY = = oe BALANCE VOLUME
ow
PHONES A 8B w~, LOUDNESS . 0. 2 Ae PHONO VIDEO CD ib
® GOGO Oe© t-¢> gooe ©
: 4 24
— —ao
EI. Es
1 2 3° 4 5 6 7 8 9 10 11 12 13
REAR PANEL
41. AC Line Cord. 8. Phono Ground. 15. Tape 2 Input/Output.
2. AC Outlets 9, Phono Input. 16. Preamp Out, Main In.
3. Speakers A. 10. MM/MC Selector. 17. Soft Clipping On/Off.
4. Speakers B. 11. Infrasonic Filter. 18. Bridging.
5. AM Rod Antenna. 12. CD Input. 19. Speaker Impedance.
6. AM Antenna Terminals. 13. Video Sound Input.
7. FM Antenna Input. 14. Tape 1 Input/Output.
Le sigs
5 GROUND
VIDEO TAPE 1
PHONO SOUND iN OUT
* INFRASONIC
L—®
SWITCHED
I
NSWITCHED
(MPEDANCE
81) (HIGH) 422 (NORMAL)
+ MONO (-)
SOFT CLIPPING BRIDGING
ON OFF] ON OFF
OTE: WHEN IN MONO PUT IMPEDANCE SWITCH IN 48) POSITION.