9
ENGLISH
FRANÇAISDEUTSCHNEDERLANDSESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
SETUP FOR CUSTOM AND MULTI-ZONE INSTALLATIONS
REMOTE CONTROL CODES
The NAD C 422 has a remote control command receiver built in so it will
respond to NAD remote control commands, such as from most NAD
system remote controls (SR-4, SR-5, S70; not supplied with C 422). This
will allow access to basic functions such as preset up/down, On/Stand-
by.
Particularly with Custom Install in mind, the NAD C 422 will respond to
other commands not usually found on NAD remote control handsets.
The table below indicates all commands the C 422 recognises.
The NAD C 422 uses the NEC format for IR transmission; customer code
is 877C, the corresponding hex codes are next to the IR command:
Footnote Function Hex Code
1Preset D2
Preset D1
2 Search 87
Search 86
3Tune D4
Tune D3
4Preset 1 8A
Preset 2 8E
Preset 3 92
Preset 4 94
Preset 5 8B
Preset 6 8F
Preset 7 03
Preset 8 97
Preset 9 98
Preset 0 C7
5 Enter C5
6 Power/standby toggle 80
7 Power On 25
8 Standby C8
1Preset and scroll trough presets, with wrap-around.
2 Search and will engage auto-searching, with wrap-
around.
3Tune and will engage tuning. if command received for
more than 1 second, auto-search is engaged; wrap around
4Preset 1-9, 0: Allows direct entry of preset number. First send desired
number code, send Enter code to confirm. If preset is empty, tuner
will default to current status.
5 Enter: To confirm and engage preset number. Program small macro
with preset 1-9,0 and enter to gain direct preset access.
6 Power/Stand-by toggle: Switches tuner from On to Stand-by and
vice-versa. This code is also used on other re mote controlled
products.
7 Power On: To avoid sync problems with other NAD products also
using the Power/Stand-by toggle, the C 422 responds to separate On
code in addition; if already switched on, it will remain on.
8 Stand-by: For same reason as above. If already in Stand-by mode, it
will remain so.
12V TRIGGER INPUT
NAD components equipped with 12V output triggers are fully
compatible with the C 422’s 12V input trigger.
Plug type: 3.5mm mono mini-jack
Operating range: 6 to 15 V DC
Current drawn: <10mA
Centre pin = +
Shaft = –
To Next Page
Loading...
