NAD S100 - Troubleshooting Common Issues; No Sound Issues; One Channel Sound Issues; Phono Input Problems

GB
7
TROUBLESHOOTING
NO SOUND • Power Mains cable unplugged or power
not switched on
• TAPE 1 MONITOR selected
• Mute on
• Connector to power amp not fitted correctly
• Internal fuse blown
• Power amp or active speaker
not switched on
• Check if AC Mains cable is plugged in and
power switched on
• De-select monitor mode
• Switch off Mute
• Check connections
• Consult dealer
• Switch power On
Problem Cause Solution
NO SOUND IN ONE CHANNEL • Connector to power amp not fitted correctly
• Input lead disconnected or damaged
• Check connections
• Check leads and connections
PROBLEM ON PHONO INPUT ONLY • No signal
• Hum on Phono input
• Weak or Distorted signal
• No phono amplification module installed
• Check MM, MC switch set correctly
Check phono earth lead is connected
• Check the turntable is connected to the
correct MM or MC phono input
REMOTE CONTROL NOT WORKING • Batteries flat, or incorrectly inserted
• IR transmitter or receiver windows
obstructed
• Check or replace batteries
• Remove obstruction
WEAK BASS / POOR STEREO IMAGE • Speakers connected to the power
amplifier wired out of phase
• Check connections to all speakers in the
system