NAD T 775 - Factory Reset; Delete Mode

FACTORY RESET
The HTR 3 can be reset to its factory state, deleting all learned commands, copied and punched-
through keys, macros, and other setup information, reverting all keys to their pre-programmed library
commands.
To perform a factory reset simultaneously press-and-hold for 10 seconds the HTR 3’s [ON] and
[RTN] keys; the Learn LED will start to ash green. Release [ON] and [RTN] before the second ash is
complete; the Learn LED will turn red, indicating the remote has been reset.
NOTE
 :PVNVTUSFMFBTF<0/>BOE<35/>CFGPSFUIFTFDPOEøBTIHPFTPVUPUIFSXJTFUIFVOJUXJMMOPUSFTFU
TIPVMEUIJTPDDVSSFQFBUUIFGVMMQSPDFEVSF
DELETE MODE
The HTR 3 can store learned, copied, and “default library” commands on any single key (The default
library commands are the pre-programmed NAD codes, such as the native T 775 commands on the
[AMP] “page.”).
You can delete commands by layers back “down” to the default library command on any key, removing
learned commands, punched-through functions, and copied keys.
NOTE
 5IFEFGBVMUMJCSBSZDPNNBOETDBOOPUCFEFMFUFETPZPVOFFEOPUXPSSZUIBUVTJOH%FMFUF.PEF
NJHIUDBVTFJSSFQBSBCMFDIBOHFT
To enter Delete Mode, simultaneously press-and-hold for 3 seconds both the desired key’s Device
Selector key and the [RTN] key, until the Learn LED turns green. Press the function key whose
command you wish to delete; the Learn LED ashes; the number of times indicates which type of
function has become active - see the table below. Press the active Device Selector key again to exit
Delete Mode.
NOTE
 :PVNBZEFMFUFNVMUJQMFGVODUJPOLFZDPNNBOETPOUIFTBNF%FWJDF4FMFDUPSiQBHFwCVUUPEFMFUF
GSPNNPSFUIBOPOF%FWJDF4FMFDUPSQBHFZPVNVTUFYJU%FMFUF.PEFBOEUIFOSFFOUFSJUPOUIF
required page.
Flashes Command Type
1 Default Library Command
2 Copied Library Command
3 Learned Command
OPERATION
USING THE HTR 3 REMOTE CONTROL
40
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ