NAD T 778 - Operation; Tone Controls; Front Panel Display Setup; Speaker Setup

ENGLISH
23
Tone Controls: Tone Defeat/O
Front Panel Display Setup: Set “BluOS Source Front View” to “Cover Art
and Meta Data”
Speaker Setup: from the Speaker Setup menu, go to “Speaker
Conguration” sub-menu and change “Height 1” and “Height 2” from
“O” to “Small”.
2 With the above settings, scroll to “A/V Presets” from the SETUP MENU
page. Use [S] to access “A/V Presets” menu.
3 At “A/V Presets” page, set “Preset: 1” to the following conditions - use
[D/F] to select “Yes” and press [ENTER] to conrm selection and move
on to the next setting.
While at “Save Current Setup to Preset” menu line, use [S] to save the
above settings to Preset 1. Below OSD will be shown, arming that the
above settings are now saved to “Preset 1”.
When you recall “Preset 1” using the remote control (for HTR 8, “A/V
PSET” + “1”), the above preset values allocated at “Preset 1” (preset
settings as shown in the OSD captures at Step 1) will be recalled and
eected at the current source.
4 Now, repeat again Step 1 above but this time with the following
settings
Listening Modes: Dolby Surround/Neural:X/None
OPERATION
CONFIGURING T 778  SETUP MENU VIA ONSCREEEN DISPLAY