NAD T765 - Specifications; Power Amplifier Section; Preamplifier Section; AM Band

POWER AMPLIFIER SECTION
Minimum continuous Power (FTC) 140W
Power output, Stereo Mode 120W
 (ref.4/8Ω,bothchannelsdriven
 atrateddistortion)
SimultaneousFullDisclosurePower 7x80W
 (ref.4/8Ω,allchannelsdriven
 atrateddistortion)
IHFdynamicpower,8Ω 160W
IHFdynamicpower,4Ω 260W
IHFdynamicpower,2Ω 360W
RatedTHD <0.08%(ref.20Hz–20kHz)
IMdistortion,ratedpower <0.08%
Dampingfactor,8Ω >60
Inputsensitivityandimpedance 1.1V/50kΩ
Frequencyresponse ±0.8dB(ref.20Hz–20kHz)
Signal/Noiseratio >92dB(ref.ratedpower,8Ω,A-weighted)
 >82dB(ref.1W,8Ω,A-weighted)
PREAMPLIFIER SECTION
Inputsensitivityandimpedance 350mV/50kΩ
Frequencyresponse ±0.5dB(ref.20Hz–20kHz)
Signal/Noiseratio >88dB(ref.2V,A-weighted)
AMBAND
Frequencyrange 530kHz-1710kHz(120Vversiononly,10kHzsteps)
531kHz-1602kHz(230Vversiononly,9kHzsteps)
Usablesensitivity 30dBu
Signal/Noiseratio >38dB
TotalHarmonicDistortion <3%
Loopsensitivity20dBS/N 66dBu
FMBAND
Usablesensitivity,Mono <16.1dBf
Signal/Noiseratio,Mono 60dB
Signal/Noiseratio,Stereo 55dB
TotalHarmonicDistortion,Mono 0.25%
TotalHarmonicDistortion,Stereo 0.5%
ChannelSeparation,1kHz 40dB
Frequencyresponse ±1.5dB(ref.30Hz–15kHz)
RDSdecodesensitivity 28dBu
DIMENSIONS AND WEIGHT
Dimensions(WxHxD) 435x170x431mm(Gross)
NetWeight 19.8kg
ShippingWeight 24.7kg
*Grossdimensionsincludefeet,extendedbuttonsandrearpanelterminals.
Note:Installersshouldallowaminimumclearanceof55mmfor
wire/cablemanagement.
> S P E C I F I C A T I O N S