FLAMIN’ FINGER™ Operator’s Manual
2
2.0 INTRODUCTION
Namco’s FLAMIN’ FINGER
™
is a 1-player (linkable up to 64 players) redemption game
featuring randomly generated mazes on a touch-screen.
Complete the maze within the time allowed and win the JACKPOT!
3.0 PRECAUTIONS
3.1 Installation
This game is designed for indoor use only. It must not be installed outdoors. The
following conditions must be avoided:
1. Direct exposure to sunlight, extreme high humidity, direct water contact, dust,
high heat or extreme cold.
2. Vibration. The game must be installed on a level surface with levelers
properly adjusted.
Do not install in an area such that the game would present an obstacle in case of an
emergency (i.e., near fire equipment or emergency exists).
3.2 Handling
1. Before operating the game, make sure that the main AC power hookup
includes a safety ground. This will ensure safe operation as well as
compliance with the applicable FCC and UL regulations. Measure the AC
power line voltage. Verify that the voltage source is between 110 and 125
VAC.
2. Before replacing any parts, turn the AC power OFF and unplug the game.
3. The game includes areas where 120 VAC is present. Take care at all times
to avoid electrical shock whenever inspecting or adjusting the game.
4. Do not attempt to repair the Printed Circuit Board (PCB) on-site. It contains
sensitive integrated circuit chips that could be easily damaged, even by the
small internal voltage of a multi-meter. Always return the PCB to your
distributor for any repairs. PCB assemblies must be returned as complete
sets.
To Next Page
Loading...
Need help?
General
