NaNNi iNdustries s.a.s.
11, Avenue Mariotte
Zone Industrielle
33260 La Teste - France
Tel: +33 (0)5 56 22 30 60
Fax: +33 (0)5 56 22 30 79
NANNI MARINE DIESEL ENGINES
ENGINE RESPONSABILITY
Nanni engines are assembled and tested in view to
have minimum environmental impact as possible.
This objective, however, can only be achieved with full
cooperation of the end user.
Operating and maintenance instructions issued in the
Company User Manuals are providing the best help
for the user to protect their engine(s) and to adopt
environmentally responsible behaviour.
Nanni engine(s) users must ensure that they only use
recommended fuels and oils. Using another type of
fuel or oil could cause major malfunctions, an higher
fuel consumption, a reduced engine service life, and a
greater discharge of exhaust gases.
When draining the oil and changing the oil or fuel lter,
dispose of the waste in an appropriate container.
These fluids cause major damage to flora and fauna
if discharged into nature. Use an absorption kit in the
event of accidental discharge of oil or fuel into the
water.
CUSTOMER ASSISTANCE
Should you have any question regarding the Emission
Control System, your authorized Nanni dealer will be
glad to inform you and to guide you for the correct
care and operating procedures to follow on your en-
gine. Should you be in need of additional assistance,
please contact:
NANNI INDUSTRIES S.A.S.
11, Avenue Mariotte
Zone Industrielle
33260-La Teste
France
Phone: +33 (0)5 56 22 30 60
Fax: +33 (0)5 56 22 30 79
Web: www.nannienergy.com
WARRANTY LIMITATIONS
As far as Nanni Industries S.A.S engines are EPA
certied, it means that the Company guarantees that
all engines of the same type that are manufactured
are approved and certied by the authorities in
accordance with different exhaust emissions
standards.
However, for the engine to be in accordance with this
standards, specic requirements for maintenance
and service are to be followed:
• Only Nanni replacement parts must be used.
• Maintenance intervals must be observed.
• The engine must not be modied in any way
except with accessories and service kits approved
by Nanni Industries S.A.S. France.
• Service of the fuel system must always be carried
out by an authorized Nanni workshop.
• No modications to the air intake and exhaust
system may be undertaken.
• Seals may only be undone by authorized personnel.
• The operation instructions stated in the relevant
manuals must be follow by the user.
Nanni’s responsibility for the engine specication
being in accordance with the certication will be void
if one or several of above conditions are not followed.
To Next Page
Loading...
Need help?
General
