EasyManua.ls Logo

Nanni V6.270 - Replacing the Fuel Prefi Lter; Draining the Water from the Fuel Prefi Lter

Nanni V6.270
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance
Fuel system
Replacing the fuel pre lter
The fuel pre lter is an optional component that puri es the
diesel before it is injected in the engine. These instructions
are given as an example only.
Close the fuel valve on the fuel tank.
Place a pail under the fuel pre lter. Remove the lter
tank A
Drain and clean the lter tank.
Replace the cartridge B and re-install the tank.
Open the fuel valve. Drain the feed system then start
the engine to check the leak-tightness.
Draining the water from the fuel pre lter
Before starting the engine each time, ensure there is no
water in the fuel pre lter. If there is water, place a tray under
the fuel pre lter and then drain the water and impurities
using the bottom cap/valve.
B
A
19

Related product manuals