EasyManua.ls Logo

NAPCO StarLink Series - NFPA 2010 AHJ Inspection Guide: Signal Loss Test; Signal Loss Test Procedure

NAPCO StarLink Series
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16 NAPCO StarLink Fire: Getting Started Guide
Signal Loss Test
This test ensures that the SLECDMA-CFB-PS will indicate a supervisory trouble condition to the FACP and cen-
tral station upon loss of signal within the required time period.
Remove the antenna and observe the following indications:
Reconnect the antenna:
Note: In cases where the radio may be located in close proximity to the cell tower, there is a possibility that the
radio may operate properly, even with the antenna removed.
LED Verify this Condition Passed?
Red Trouble LED D5 Blinks 5 times.
Yellow Trouble LED on
SLE-ULPS-R
Blinks 4 times.
Trouble Relay Output on
SLE-ULPS-R
Activates within 5 minutes; check for proper trouble annunciation at
FACP.
Supervisory signal E356 will be received by the central station within
5 minutes of the antenna being removed.
Red Trouble LED D5 Turns off.
Yellow Trouble LED on
SLE-ULPS-R
Turns off.
Trouble Relay Output on
SLE-ULPS-R
Restores; check for proper trouble restoral at FACP.
Supervisory restore signal R356 will be received by the central station
within 5 minutes of the antenna being reconnected.

Related product manuals