To Next PageTo Next PageWhat to do if my Napoleon Indoor Fireplace pilot flame is not engulfing the thermocouple?
If the pilot flame is not engulfing the thermocouple on your Napoleon Indoor Fireplace, turn up the pilot flame. If that doesn't work, replace the pilot assembly.
What to do if my Napoleon GDS 50-N has a thermocouple shorting?
If the thermocouple in your Napoleon Indoor Fireplace is shorting, try loosening and tightening it, and clean the thermocouple and valve connection. If the issue persists, replace the thermocouple or the valve.
Why is the flame impinging on the logs in my Napoleon Indoor Fireplace?
If the flame is impinging on the logs or combustion chamber of your Napoleon Indoor Fireplace, check that the logs are correctly positioned. Additionally, you can open the air shutter to increase the primary air. Also, verify the input rate by checking the manifold pressure and orifice size as specified by the rating plate values. Ensure the door gasketing is intact and provides a tight seal. Finally, check that both vent liners are free of holes and well sealed at all joints, and that minimum rise per foot has been adhered to for any horizontal venting.
How to fix carbon deposits on the glass of my Napoleon GDS 50-N Indoor Fireplace?
If carbon is being deposited on the glass, logs, or combustion chamber surfaces of your Napoleon Indoor Fireplace, the air shutter may be blocked. Ensure the air shutter opening is free of lint or other obstructions.
What to do if my Napoleon GDS 50-N has exhaust fumes and headaches?
If you smell exhaust fumes in the room or experience headaches when using your Napoleon Indoor Fireplace, check all the seals to ensure they are properly fitted and not damaged.
Why does the pilot light go out on my Napoleon GDS 50-N Indoor Fireplace?
If the pilot light goes out on your Napoleon Indoor Fireplace, it might be because the system wasn't correctly purged. Purge the gas line with the glass door open to resolve this.
What to do if there's no gas at the pilot burner of my Napoleon GDS 50-N Indoor Fireplace?
If there's no gas at the pilot burner of your Napoleon Indoor Fireplace, check that the manual valve is turned on and inspect the pilot orifice for any blockage. If these steps don't resolve the issue, consider replacing the valve. If problems persist, contact the gas distributor.
General| Ignition System | Electronic Ignition |
|---|---|
| Control Type | Remote Control (Optional) |
| Log Set Material | Ceramic Fiber |
| Burner Material | Stainless Steel |
| Fuel Type | Natural Gas |
| Vent Type | Direct Vent |
| Heating Area | Up to 1, 200 sq. ft. |
| AFUE | Not Applicable |
General safety guidelines for stove operation.
Emergency procedures in case of a gas leak.
Important warnings about high temperatures and flammable materials.
Procedures for connecting gas supply and electrical components safely.
Specifies minimum clearances to combustibles for GDS50 and GS50 models.
Details clearances for installing the GD150 insert model.
Guidelines for vent pipe lengths and air terminal placement.
Detailed table of clearances for air terminal installations in Canada and USA.
Instructions for connecting the gas supply to the unit.
Function of spill switch and testing venting action.
Essential safety reading before operating the unit.
Step-by-step guide for lighting and turning off the fireplace.
Solutions for pilot not lighting or main burner problems.
Diagnosing and fixing flame issues and venting problems.
Troubleshooting blower operation and door sticking problems.
