W415-1320 / 06.26.14
NZ64 & GA65
INSTALLATION INSTRUCTIONS FOR MODEL HDX52
:ROI6WHHO/WG1DSROHRQ5G%DUULH21/0*&DQDGD ID[ ZZZQDSROHRQILUHSODFHVFRP
NOTE: Consideration should be made for blower location as the closer to the
appliance, the greater the air fl ow noise will be.
A. For wire harness installation remove the lock washer and nut that secure the
blower to the blower housing. Remove the blower from the housing by lifting
up and out, as shown.
B. Connect the wire harness to the left side of the blower.
C. Loosen the nut that secures the junction box to the blower housing.
Remove the junction box, as shown.
D. Guide the end of the wire harness through the bushing in the junction box
and then through the junction box plate.
E. Re-install the junction box.
F. Re-install the blower.
G. Position the blower to an inside wall into a framed opening 12
3
/
8
” wide by 10
1
/
2
”
high, as shown below.
NOTE: The blower housing should be installed onto a level surface large enough to support the blower assembly
for dimensions. Allow for fi nishing material when securing the blower housing, as the grill mounts to the
housing. Ensure the blower is oriented properly with the footings of the blower housing at the bottom, refer to
the illustration below.
!
WARNING
ENSURE THE UNIT IS COMPLETELY COOL BEFORE STARTING INSTALLATION
TO AVOID DANGER OF SUFFOCATION KEEP THE PACKAGING BAG AWAY FROM BABIES AND CHILDREN.
DO NOT USE IN CRIBS, BED, CARRIAGES OR PLAY PENS. THIS BAG IS NOT A TOY. KNOT BEFORE
THROWING AWAY.
JUNCTION
BOX
A
C
JUNCTION BOX
COVER PLATE
10.75”
14.25”
10.25”
12.25”
10.75”
1.25”
Footings
WARNING: UNPLUG ALL ELECTRICAL CONNECTIONS BEFORE BEGINNING WITH INSTALLATION.
ELECTRICAL CONNECTIONS MUST BE MADE BY A CERTIFIED ELECTRICIAN.
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE.
CONSUMER: RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
12
3
/
8
”
10
1
/2”
I
NSIDE W
A
LL
LEV
E
L SU
R
F
A
C
E
To Next Page
Need help?
General
