Napoleon ROGUE SE 425 RSIB User Manual

6
| Getting Started
Napoleon.com | Rogue® Series Grills
1
3
2
Getting Started
WARNING! Do not store a spare gas cylinder below the grill head or side burners.
WARNING! Never use a gas cylinder that is beyond 80% full.
WARNING! Follow all specifications and instructions exactly to prevent fire, explosion, property damage, personal
injury, or death.
WARNING! Disconnect the grill and its individual shutoff valve from the gas supply piping system during any
pressure testing in excess of ½ psi (3.5 kPa).
WARNING! Close the individual shutoff valve to isolate the grill from the gas supply piping system during any
pressure testing equal to or less than ½ Psi (3.5 kPa).
!
gaS connectionS
Option 1: To a Gas Cylinder
Use a propane cylinder of minimum 6 kg or a butane cylinder of 13 kg
constructed and marked in accordance with national and regional codes. Ensure
that the cylinder can provide enough fuel to operate the appliance. If in doubt,
check with your local gas supplier.
Use a gas pressure regulator and hose supplied by Napoleon; if not included, use
a regulator and hose that meet national and regional codes. The recommended
length of the hose is 0.9m. The hose must never be longer than 1.5m.
Note: The hose should be replaced before the expiry date printed on it.
Only place cylinders within the maximum width and height dimensions inside the
enclosure on the bottom shelf. Cylinders that surpass the maximum dimensions
must be placed outside the enclosure on level ground. Refer to the diagram below
for specific measurements.
Hook-up and Installation
• Check the cylinder for dents or rust, and have it inspected by your gas
supplier.
• Never use a cylinder with a damaged valve.
• Place the cylinder in its designated area on the bottom shelf.
• Ensure the gas regulator hose has no twists or kinks.
• Remove the cap or plug from the cylinder fuel valve.
• Tighten the regulator to the cylinder valve.
• Ensure the hose does not contact with the drip pan or any high temperature
surfaces of the grill because it will melt and cause a fire.
• Ensure the cylinder is not left exposed to extreme heat or direct sunlight.
• Leak test all joints prior to operating the grill. See “Leak Test”.
310 mm
590 mm
Maximum Cylinder Dimensions

Napoleon ROGUE SE 425 RSIB Specifications

General

Brand	Napoleon
Model	ROGUE SE 425 RSIB
Category	Grill
Language	English