——the “alarm status” Subdirectory
——Overvoltage alarm YES/NO
——under voltage alarm YES/NO
——Over temperature YES/NO
——under voltage alarm YES/NO
——under capacity alarm YES/NO
——Difference voltage YES/NO
——Overcurrent YES/NO
——Charger Reverse alarm YES/NO
——the “protection status” Subdirectory
——Overvoltage protect YES/NO
——under voltage protect YES/NO
——over temperature protect YES/NO
——under temperature protect YES/NO
——over current protect YES/NO
——Short current protect YES/NO
——the “Fail alarm” Subdirectory
——Sampling line: OK/ERROR
——Charge MOSFET: OK/ERROR
——Discharge MOSFET: OK/ERROR
——Sampling chip: OK/ERROR
——Short current times: xxxx
——Temperature protect times: xxxx
——over protect times: xxxx
——Over current times: xxxx
——under voltage times: xxxx
The “Battery parameter settings” Subdirectory Non-manufacturers cannot enter 10 NPFC series
LiFePO4 Battery System for Telecommunication Operation manual V1.0
The “Version Information” Subdirectory
——the “BMS version” Subdirectory
——BMS software version
——BMS hardware version
——the “LCD version” Subdirectory
——LCD software version:
——LCD hardware version:
LCD Instructions BMS under sleep mode please press “MENU” wake the BMS and LCD With in
one minute without operating LCD into turn off: Please press “MENU” wake the BMS and LCD
To Previous Page
Loading...
