Narda 5G LNB Antenna 41
EN
5 Setup and installation
5.1 Power supply
The standard power supply is provided via the integrated battery. Therefore
the LNB antenna does not affect the runtime of the SRM-3006 basic unit.
The battery of the LNB antenna is pre-charged upon delivery and must be
fully charged before first use. The LNB antenna can be connected to a
power supply via a USB-C cable for operation and for charging the internal
battery. Connected to a USB power bank, long-term measurements can
also be performed.
NOTE: Please make sure that the AC power cord is equipped with a ferrite filter
positioned next to the LNB antenna power supply. This is important to
ensure the power supply is in line with the EMF standards mentioned in the
datasheet.
Charging the batteries:
Mains voltage must correspond to the operating voltage of the charging/
power supply device.
1. Connect the charger/power supply device to the charging USB socket of
the LNB antenna.
2. Connect the charger/power supply to the mains.
Charging starts immediately.
The Battery status LED lights red during the charging cycle.
When the battery is charged, the Battery status LED lights green.
3. Remove charger/power supply device.
Battery error
A red flashing Battery status LED signals a battery error.
In this case unplug the antenna from the SRM-3006 basic unit and
contact your Narda representative.
To Next Page
Loading...