Which channels are occupied? The bar
graph display in ‘Safety Evaluation’
mode shows maximum, average, and
minimum values simultaneously, so you
can clearly see what’s going on.
UMTS P-CPICH Demodulation: The SRM
automatically identifies every received
UMTS cell by means of its scrambling
code and measures the field strength
or power density of the associated
pilot channel (P-CPICH) at the same
time. The SRM also shows the sum of
all P-CPICH levels as an overall value
(Total). The analog measured value for
the frequency channel is also shown for
comparison. You can also set a factor
that the SRM can use to extrapolate
the field strength that would result
if all channels were fully loaded.
View pulsed signals directly in ‘Scope’
mode: The time domain display can be
set to cover a period of 24 hours or can
be more finely resolved, even down to
the microsecond level.
Measure pulsed signals easily in ‘Level
Recorder’ mode: The SRM complements
the numerical display of maximum
and minimum values with a bar graph
‘thermo meter’ display: A marker remains
on the maximum level in each case.
To Next Page
Loading...
