37
Master setup
1. Supply power to the master.
2. If not yet completed, perform the initial configuration as described on chapter 6.2
3. Initial view is shown:
4. Scroll until:
5. Press ENT
6. Press ENT
7. Insert password (default 001).
8. Scroll until:
9. Set ON
10. Set:
Address in COMBO operation.
Function to allow alternating between the pumps connected in parallel in order to
allow equal use of each pump in the group; in this way Master will reorganize the
starting priority of the pumps by checking the life of each of them.
Delay time with which the slaves start after the variable speed pump has reached
the maximum frequency and the pressure value has fallen below set value – delta
control
11. Press STOP (red button)
12. Press STOP again
Start delay AUX
t = XX [s]
Inv: ON/OFF Mot: ON/OFF
p_mis=XX.X [bar]
To Next Page
