BNC-2111 Installation Guide 10 ni.com
Connecting Analog Output and PFI Signals
Connect each AO signal to the appropriate BNC connector
(AO Channels 0–1).
Use the BNC connectors to connect or access PFI signals on your DAQ
device. Figure 4 shows these connections. Refer to Table 6 in the
Specifications section for more information.
Figure 4. AO and PFI Connections
AO 0
AO 1
APFI 0
PFI 0/P1.0
PFI 2/P1.2
PFI 7/P1.7
PFI 12/P2.4
PFI 13/P2.5
AO GND
D GND
To Next Page
Loading...